How To Setup – Samsung Galaxy Gear
Learn how to setup your Samsung Galaxy Gear. These steps take you through an out-of-the-box setup process. These procedures are intended to help you get your device setup, activated, and assist you with your initial connection.
Charging the Battery
- Your device is powered by an internal rechargeable Li-ion battery. Use only approved chargers with this device. Ask your local Samsung dealer for further details.
Note: It is recommended you fully charge the battery before using your device for the first time.
Note: If the battery is completely discharged, the device cannot be turned on. Allow a depleted battery to charge for a few minutes before turning on the device.
- Before turning on your Galaxy Gear for the first time, charge it fully.
- In a single motion, slide and hold the switch (1) to open the Charging cradles protective cover
- Carefully place the device onto the cradle (3), making sure to align the connector plates to the charging pin
- Firmly close the cover
- Insert the power plug into a compatible electrical outlet.
- Insert the USB connector into the Charging cradles charger jack.
Note:Connecting the charger improperly may cause serious damage to the device. Any damage caused by misuse is not covered by the warranty.
- Plug the charging head into a standard AC power outlet. The device turns on and indicates its charge state.
Note: While charging, you cannot use calling features, voice recorder, and camera.
- When charging is finished, first unplug the chargers power plug from the AC wall outlet, then disconnect the chargers connector from the device.